Swatch · chapter 8
How a Swatch was made
Automation
The key to the Swatch’s low cost was automation. The watch was designed so that every step of its assembly could be performed by machines, on a single production line, with very little human intervention. This required careful design of each part, so that it could be handled and positioned by automatic equipment. It also required a high initial investment in machinery, which would be recovered only through very large production volumes.
Plastics
The case of the Swatch was made of plastic by injection molding, a technique in which melted plastic is injected into a mold. Plastic was cheap, light and could be produced in any color. The movement components were mounted directly into the plastic case back. Even some parts of the movement, which in a conventional watch would be metal, were made of plastic.
Ultrasonic welding
Once assembled, the case was sealed by ultrasonic welding: high-frequency vibrations melted the plastic at the joint, fusing the case permanently. This made the watch water-resistant and strong, but it also meant that it could not be opened for repair. The Swatch was designed to be replaced, not repaired, a radical departure from watchmaking tradition.
Quality control
Because each Swatch could not be adjusted by hand, quality had to be built into the production process. Parts were made to tight tolerances, and the assembled watches were tested automatically. The result was a consistent, reliable product, made in Switzerland at a cost that allowed it to compete with Asian watches.