WatchShop Wiki
Articles · The Minute RepeaterWatchShop Wiki · Vol. 2

Minute repeater · chapter 3

Inside the singing watch

A minute repeater is a small mechanical computer. It reads the time, converts it into a sequence of blows and plays it at a controlled speed.

Winding the repeater

The repeating mechanism has its own power source, separate from the mainspring that drives the watch. When the owner slides the lever on the side of the case, the movement of the slide winds a small spring that will power the striking. At the same time, it releases the racks that will read the time. The repeater works only when the owner activates it; most of the time, it is silent and at rest.

Snails and racks

Three snails read the time. The hour snail, turning once every twelve hours, has twelve steps of different depths. The quarter snail, attached to the minute wheel, has four steps. The minute snail has steps for each minute within a quarter, so fourteen steps plus zero. When the slide is pushed, three racks fall against these snails. The depth of each fall sets how many teeth of each rack will pass, and therefore how many times each hammer will strike.

The hammers

As the repeater spring unwinds, it drives the racks back to their starting position. As they move, their teeth lift the hammers and let them fall against the gongs. The hour rack lifts the low hammer, the minute rack lifts the high hammer, and the quarter rack lifts both in turn to produce the double note. A part called the all-or-nothing piece ensures that the watch strikes the complete time or nothing at all, so that it cannot strike a wrong hour if the slide is not pushed all the way.

The governor

The speed of the striking must be controlled, or the notes would rush out in a jumble. A governor regulates the speed of the unwinding repeater spring. Older repeaters used an anchor governor, which made a buzzing sound. Later and finer repeaters use a centrifugal governor, a small flywheel with weights that move outward as it spins, braking it by friction or air resistance. A silent governor is a mark of quality in a modern repeater.

The sound

The sound of a minute repeater depends on many factors: the material and shape of the gongs, the way they are fixed, the weight and shape of the hammers, the force of the strikes, the material and construction of the case and even the way the watch is held. Watchmakers tune gongs by ear, filing them to adjust their pitch. Gold cases give a warm sound, platinum a duller one, steel and titanium brighter tones. Every repeater sounds slightly different.

Cathedral gongs and carillons

Some repeaters use long gongs that wind around the movement more than once, called cathedral gongs, which produce a deeper, longer-lasting sound. Others use three gongs and three hammers, called carillons, which play a short tune for the quarters. These variations add further complexity and are found in the most exclusive watches.

A minute repeater is half machine and half musical instrument.

Chiming through the centuries

  1. 1676Rack and snail

    Edward Barlow develops the striking mechanism.

  2. 1687Quare

    James II decides the dispute over the repeating watch.

  3. 1783Gong

    Breguet replaces the bell with a coiled gong.

  4. 1892On the wrist

    Audemars Piguet makes an early minute repeater wristwatch movement.

  5. 1989Calibre 89

    Patek Philippe’s grand complication includes a grande sonnerie.

  6. 2016New acoustics

    Makers redesign cases and gongs for louder sound.

The Minute Repeater · Mechanism133