WatchShop Wiki
Articles · Panerai and the Italian FrogmenWatchShop Wiki · Vol. 2

Panerai · chapter 2

The Radiomir and its secrets

A big watch

The first Panerai watches were enormous by the standards of the time, about forty-seven millimeters across. The size was deliberate: a large dial with large numerals was easier to read in murky water and darkness. The case was cushion-shaped, with wire lugs welded on to hold a long strap, long enough to be worn over a diving suit. The crown was large and screwed down for water resistance.

Made with Rolex

The cases and movements of the early Panerai watches were supplied by Rolex. Panerai was an instrument maker, not a large watch manufacturer, and it turned to an established Swiss company for the components. The cases were based on the Rolex Oyster design, with screw-down crowns and casebacks, and the movements were high-quality hand-wound calibers from Swiss suppliers used by Rolex, including Cortébert. Panerai designed the dials and assembled the watches. This collaboration, little known for decades, is today a subject of great interest to collectors.

The sandwich dial

One of Panerai’s distinctive inventions was the sandwich dial. Instead of painting luminous material onto the surface of the dial, Panerai used two plates. The lower plate was coated with luminous material, and the upper plate had the numerals and markers cut out of it. The luminous layer showed through the cut-outs, producing large, bright and well-defined numbers. The design allowed more luminous material to be used and made the dial easier to read.

The Luminor

After the Second World War, Panerai developed a new luminous material, based on tritium rather than radium, which was safer and still bright. It was called Luminor and was patented in 1949. The name was later used for a new family of watches. In the 1950s, Panerai also designed a distinctive crown-protecting device: a curved bridge on the side of the case with a lever that pressed the crown into its seal. It made the watch more water-resistant and protected the crown from knocks. The crown guard became one of the most recognizable features of Panerai watches.

The Egyptian watch

In 1956, Panerai produced a remarkable watch for the Egyptian Navy, known as the Egiziano. It was even larger than the standard models, about sixty millimeters in diameter, with a rotating bezel for timing dives. Very few were made, and they are now among the rarest Panerai watches.

Small numbers, great secrecy

Panerai produced its military watches in small numbers, perhaps a few hundred of each model. They were classified as military equipment and were not sold to the public. Their existence was known mainly to the divers who used them and the officers who issued them. For decades, Panerai remained an almost unknown name outside military circles.

Panerai and the Italian Frogmen · The watches156