WatchShop Wiki
Articles · The Accutron and the Tuning-Fork WatchWatchShop Wiki · Vol. 2

Accutron · chapter 2

Inside the Accutron

A steel tuning fork

The heart of the Accutron was a small tuning fork made of a special steel alloy, about two and a half centimeters long. At the end of each tine was a small permanent magnet, sitting inside a coil of very fine wire. A transistor circuit, powered by a small battery, sent pulses of current through the coils in time with the vibration of the fork, keeping it vibrating at its natural frequency of three hundred and sixty times per second.

The index wheel

Converting the vibration of the fork into the movement of the hands was the hardest problem. Hetzel’s solution was a tiny jewel-tipped finger, called an index finger, attached to one tine of the fork. As the fork vibrated, the finger pushed a tiny ratchet wheel, the index wheel, forward by one tooth at each vibration. The index wheel was only about two and a half millimeters in diameter, yet it had around three hundred teeth, each so small that it could barely be seen without a microscope. The index wheel drove a gear train that turned the hands.

Making the index wheel was an extraordinary feat of precision manufacturing. Bulova had to develop special machines to cut its teeth. Any imperfection would cause the watch to skip or stop.

The hum

Because the tuning fork vibrated at three hundred and sixty times per second, within the range of human hearing, the Accutron produced a faint humming sound rather than the tick of a mechanical watch. Bulova made the hum a selling point. Owners could hold the watch to their ear and hear the sound of precision.

The smooth sweep

The seconds hand of the Accutron moved smoothly around the dial, advancing three hundred and sixty times a second in tiny steps, so that its motion appeared perfectly continuous. This was quite different from the jerky step of a mechanical watch’s seconds hand or the one-second jump of later quartz watches. The smooth sweep became one of the Accutron’s signatures.

Accuracy

Bulova guaranteed that the Accutron would be accurate to within one minute a month, about two seconds a day, far better than most mechanical watches. In practice, many Accutrons performed even better. The accuracy was due to the high frequency and stability of the tuning fork, which was much less affected by position and temperature than a balance wheel.

The Spaceview

Bulova was proud of the Accutron’s technology and wanted to show it off. One of the most famous models was the Spaceview, which had no dial at all. The time was read from hands and markers on the crystal, while the tuning fork, coils, circuit and wheels were fully visible beneath. The Spaceview looked like a piece of scientific apparatus on the wrist, perfectly suited to the space age.

The Accutron and the Tuning-Fork Watch · The fork241