Deep Sea Special · chapter 4
How a watch survives a thousand atmospheres
The case
A watch case resisting pressure works like a submarine hull. The deeper it goes, the more force presses inward on every surface. The case must be thick and strong enough not to deform, and every joint must remain sealed. The Deep Sea Special used a very thick case made from a solid block of steel, with a screw-down caseback and crown.
The crystal
The crystal is usually the weakest point of a watch under pressure, because it is a large, flat surface. The Deep Sea Special solved this by using a tall, domed crystal of thick acrylic plastic. A dome distributes pressure more evenly than a flat surface, just as an arch distributes weight. Under pressure, the dome was pressed tighter into its seat, improving the seal.
The gaskets
Gaskets seal the joints of a watch case. Under extreme pressure, a good gasket is compressed even more tightly, improving the seal. The Deep Sea Special relied on carefully designed gaskets and the Oyster principle of screwing parts tightly together.
From experiment to product
The lessons of the Deep Sea Special fed into Rolex’s commercial dive watches. In 1967, Rolex introduced the Sea-Dweller, designed for professional saturation divers, and in 2008 the Deepsea, water-resistant to 3,900 meters, using a case architecture that distributes pressure through an inner ring. In 2012, Rolex made an experimental watch, the Deepsea Challenge, which was attached to the arm of James Cameron’s submersible and survived the dive to the Challenger Deep, echoing the Deep Sea Special of 1960.