WatchShop Wiki
Articles · The History of the Self-Winding WatchWatchShop Wiki

Self-winding · chapter 6

Inside the automatic winding

The rotor

In a modern automatic watch, the rotor is a semicircular weight, usually made of a heavy metal such as tungsten or gold, mounted on a bearing at the center of the movement. Because its weight is concentrated on one side, it swings and turns whenever the wrist moves, even slightly. Its motion is the source of the winding energy.

Reversing wheels

The rotor turns in both directions, but the mainspring must be wound in one direction only. A system of reversing wheels, or a mechanism such as Seiko’s Magic Lever or IWC’s Pellaton system, converts the motion in both directions into winding in one direction. Reduction gears slow the motion down and increase its force, so that many turns of the rotor wind the mainspring a little.

The slipping spring

A fully wound mainspring could be damaged if the rotor kept winding it. To prevent this, automatic watches use a slipping bridle: the outer end of the mainspring is not fixed to the barrel wall but held by friction. When the spring is fully wound, it slips around the barrel, releasing the extra tension. This simple device protects the watch from overwinding.

Power reserve

A fully wound automatic watch typically runs for about forty to seventy hours without being worn, and some modern movements much longer. If the watch is not worn for longer than its power reserve, it stops and must be wound by hand or shaken to start it again.

How much movement?

The amount of winding depends on how active the wearer is. A person who sits at a desk all day winds the watch less than one who walks or plays sport. Most automatic watches are designed to be kept fully wound by normal daily activity.

The History of the Self-Winding Watch · How it works6