WatchShop Wiki
Articles · The Oyster and Mercedes GleitzeWatchShop Wiki · Vol. 2

Oyster · chapter 3

Anatomy of a sealed case

The Oyster’s genius lay in a simple idea: screw everything shut. Executing that idea reliably in a small wristwatch case required careful engineering.

Three seals

A watch case has three main openings through which dust and water can enter: the joint between the crystal or bezel and the case, the caseback, and the tube through which the winding stem passes. The Oyster addressed all three. The bezel was screwed onto the case, holding the crystal tightly. The caseback was screwed on, compressing a gasket. And the crown screwed down onto a threaded tube, creating a seal when closed.

The case middle was machined from a solid block of metal, so there were no weak joints. Early Oyster cases were often cushion-shaped, with a rounded square outline, and later became round. The cases were robust and slightly larger than many dress watches of the period.

The screw-down crown

The crown was the most vulnerable point of any watch, because it had to be pulled out and pushed in to wind and set the watch. In the Oyster, the crown was screwed down when not in use. To wind the watch, the owner unscrewed the crown, wound it and then screwed it back down. If the owner forgot to screw it down, the watch was no longer waterproof, a weakness Rolex was well aware of and one reason it later sought to reduce how often the crown needed to be used.

Toward self-winding

The need to unscrew the crown every day to wind the watch was a practical problem. Owners forgot, or wore down the threads, and water could enter. Wilsdorf’s answer was to make the Oyster self-winding, so that the crown would rarely need to be opened. In 1931, Rolex introduced the Perpetual, a self-winding movement with a rotor that turned freely in both directions, wound by the movement of the wrist. Combined with the Oyster case, it created the Oyster Perpetual, the foundation of Rolex’s modern collection. This story is told in the chapter on the self-winding watch.

Improvements over time

Rolex continued to refine the Oyster case over the following decades. The Twinlock crown, introduced in 1953, added extra seals. The Triplock crown, introduced in 1970, added more for the brand’s dive watches. Water resistance ratings increased, first to tens of meters and later to hundreds. Sapphire crystals replaced acrylic in the 1970s and 1980s. But the basic principle remained the same as in 1926: a solid case, a screwed bezel and back, and a screw-down crown.

Industry standard

Other manufacturers developed their own water-resistant cases in the 1930s and after. Omega introduced the Marine in 1932, a dive-capable watch with a double case. Various systems with screw-down backs and gaskets became common. By the mid-twentieth century, water resistance was an expected feature of sports watches. But the Oyster had shown the way, and its name became a byword for a sealed watch case.

The Oyster’s principle has not changed in a century: screw it shut and keep the world out.

From Oyster to Oyster Perpetual

  1. 1905Wilsdorf & Davis

    The firm that becomes Rolex is founded in London.

  2. 1926Oyster

    The waterproof case is patented.

  3. 1927Gleitze

    The Oyster survives more than ten hours in the Channel.

  4. 1931Perpetual

    Self-winding reduces the need to open the crown.

  5. 1953Twinlock

    A crown with extra seals.

  6. 1970Triplock

    Further seals for dive watches.

The Oyster and Mercedes Gleitze · The case95